<TR>
<TD vAlign=center><a href="https://www.burntlatke.com/jpg600/bb-painted.jpg" target="_blank" ><IMG src="https://www.burntlatke.com/jpg300/bb-painted.jpg" border=0></A> </TD>
<TD vAlign=center>
This launcher may be built in a variety of configurations. The barrel is inside the lower pipe, the top pipe is a support where accessories can be mounted. This version uses a 2" T fitting to hold the vortex and ammo and has a 1/2" and 3/4" PVC chassis similar to the Piper design. </TD></TR></TABLE>
<TABLE cellSpacing=0 cellPadding=15 width="100%" border=0>
<TR>
<TD vAlign=center>
A cutaway view of the T fitting shows the vortex block in place. The T fitting must be sealed on all three sides which will force the incoming air and BB's through the barrel. </TD>
<TD vAlign=center><a href="https://www.burntlatke.com/jpg600/bb-graph.jpg" target="_blank" ><IMG src="https://www.burntlatke.com/jpg300/bb-graph.jpg" border=0></A></TD></TR></TABLE>